Adjustable Side Support Bicycle Kickstand Aluminium Alloy for 22 24 26in/700c US

Description

Adjustable
Side
Support Bicycle Kickstand Aluminium Alloy for 22 24 26in/700c
Features:
Wide Application: Suitable for most 22 24 26 inches bike and 700c road bike; Suitable for the rear chains tube diameter from 15 * 26mm to 22 * 30 mm
Adjustable Bicycle Kickstand: The kickstand could be easily adjust to the right height by loosening the middle screw with the attached hex wrench; The total length of the bike support ranges from 34 cm to 39 cm
Material: Made of strong and durable Aluminum Alloy with anti-slip pad, can prevent the bicycle from slipping on wet surfaces
Easy Installation: This mountain bike kickstand with wrench to loosen the middle of screw, length can be adjustable. Package include free 4mm, 8mm wrench for you to easily install.
Non-slip Foot: The Aluminum Alloy Bicycle Kickstand comes with an wide anti-slip reinforced rubber foot to prevent slipping on wet surfaces and sinking in mud.
Note： This kickstand fits for 22" 24" 26" Bikes and 700c Road Bike, but not suitable for bike size below 22 inch or above 26 inch. Please contact us if you have any questions with the bike kickstand.
How to Install This Bike Kickstand?
Remove three screws with the 5mm hexagon wrench
Align the aluminum alloy sheets with the inner rubber mats to the chain stay tube, then tighten the screws
Try to put down the kickstand, and check if the bike is balanced
If not, use the 4mm hexagon wrench to loosen the screw in the middle of the kickstand and tighten the screw after adjusting to the appropriate height.
Specification:
Material: Aluminum Alloy & Rubber
Weight: 320g
Size: Width: 4.5cm, Length: 35cm~39cm
Oval Tube: 15-22mm*26mm; Square Tube: 15-22mm*30mm
Package Included:
1 × Kickstand
1 × 4mm Hexagon Wrench
1 × 5mm Hexagon Wrench
TIPS:
Pay attention to the position of the kickstand. If it is too far forward, the heel will easily be touched whe
n riding.
Don’t twist the screws again after you tightening them, otherwise it is easy to make the thread worn down.